Navigatie

Roger handzender E80/TX52R - E80/TX54R - M80/TX44R 433mhz

Vorige Artikel 16 van 31 Volgende
€ 38,00 (exclusief 21% BTW)
Aantal

BUTTONS FUNCTIONS

The buttons does not have predeterminated function and they can be

memorized in any receiver channel.

INSERTING A CODE

When the receiver powered press the channel button where you want to

memorize the transmitter. When the button is released the relative led will

blink slowly 3 times, during this period press the button of the remote control

in which the code is to be stored. A long blink indicates that storage has been

successful, while 3 consecutive fast blinks indicate that the code of the remote

control has already been stored in one channel. The led will emit another 3

slow blinks while waiting for other storage procedures. If no other codes are

transmitted in this time, the receiver exits from the programming phase.

It is impossible to store the same code on both channels; each code is

associated with just one channel.

CHANGING BATTERY

To change the battery remove the two screw with a screwdriver on the

transmitter back (FIG. 2).

Pay attention to the battery polarity marked on the battery holder.

TRANSMITTER COPY

This transmitter is able to copy the code from another fixed code transmitter.

Be careful when you copy, it must be done by advised person and with good

battery, otherwise the copy does not work.

Follow these steps to copy a remote control:

• On the COPY transmitter push the button where you want to memorize the

code together with the opposite button (A with B, or C with D).

• The LED blinks for 5 seconds, after it becomes fixed

• Hold the button where you want to memorize the code and release the

other

• The LED sends out 3 long blinks

• In the meantime place the ORIGINAL transmitter in front of the COPY (FIG.

1) and push the ORIGINAL transmitter button that you want to copy

• The LED sends out short flashes waiting a code to copy

• Now take pay attention to the COPY transmitter LED:

– If the LED turns on for 1 second and after turns off the copy is done. Now

you can release all buttons. It is strongly recommended to check that the

code is recognised by the receiver, otherwise repeat all steps.

– If the LED continues to send out short blinks, it means that no codes are

received, so be sure to push the ORIGINAL transmitter button or move

the transmitter to maximize the signal coupling. However if it does not

copy change the battery of ORIGINAL transmitter

– If the LED still on, the copy is failed, please retry.

– If the LED send out fast blinks and after it still fixed, it means that the

battery has not enough energy to perform the copy

Winkelwagen

Geen artikelen in winkelwagen.

Verzendkosten.

In Nederland en Belgie=0,00€

Volg ons op:

    

 

© 2016 - 2019 poortopenershop.com | sitemap | rss | webwinkel beginnen - powered by Mijnwebwinkel